Abus TVIP11502 Mode D'emploi page 63

3. Installation
Make sure that all accessories and parts listed above are present in the scope of delivery. An Ethernet cable
is required for camera operation. This Ethernet cable must meet UTP Category 5 (CAT 5) specifications and
must not be longer than 100 metres.
3.1 Power supply
Before starting installation, ensure that the mains voltage and the rated voltage on the power supply unit are
identical. The camera's supply voltage is 5 VDC. Please use the supplied power supply
3.2 Installing the camera
With the camera a mounting bracket is supplied. At the backside of the camera a socket is located. Using this
socket the camera mounting bracket can be fixed at the camera. The mounting bracket can be fixed at the
wall unsing the supplied pegs and screws.
4. Camera description
4.1 Description of connectors
Front side
3
2
4
1 Lens
2 Network status LED
3 Status info LED
4 IR LEDs
5 Light sensor
6 Microphone
1
5
6
7
a
7 Power supply connector
8 Micro-SD card slot
9 Network connector
a Reset button
b WPS button (only TVIP11552)
c Antenna connector (only TVIP11552)
63
Back side
8
9
b
c