COMAC NUOVA CARPET Manuel D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Upon finishing the task, discharge the collected liquid from the recovery tank through the discharge drain. If necessary, take off
the tank after removing the suction hose and the plug. Always rinse the tank thoroughly to prevent unpleasant smells.
Clean regularly the net filter with the two floating spheres.
Put the filter, the suction plug and the discharge plug back in place.
Once all the product of the solution tank has been distributed, cleaning of the tank is recommended removing any impurities from
the bottom and then refill the detergent up to the correct level.
MAINTENANCE
At least on a monthly base, empty and clean the tanks and the solution and suction filters
Wash the brush thoroughly with water and soap and let it dry
Check the conditions of the mains lead and of the plug.
Check the conditions of the gasket of the suction plug and, if necessary, replace it
EXTENDED MACHINE INACTIVITY
If the machine is not going to be used for a few days, to ensure long machine life, fill the solution tank with clean water and make it
flow out to thoroughly wash the circuit so to prevent the detergent from drying inside it and maybe clog it.
TROUBLESHOOTING GUIDE: DEFECTS, CAUSES AND SOLUTIONS
Symptom:
Cause:
Solution:
Symptom:
Cause:
Solution:
In the car
On seat upholstery, doors and mats.
For cleaning car ceilings. Thanks to its foam system there is no
annoying dripping
At home
On arm-chairs and carpets at home, in the office and in public
environments.
ATTENTION !
Use exclusively concentrated detergents of the Euroself FOAM INDUSTRIAL line to
be diluted with a ratio of 1 liter of product every 40 liters of water.
Nuova
Carpet
Nuova
Carpet
- The machine does not start
- The plug is not connected to the mains
- The fuse has burnt.
- Make sure there is voltage and then connect the machine to the mains outlet
- Check that the fuse is intact
- The internal compressor suddenly stops
- The thermal protection of the motor is activated
- The internal compressor is provided with a self-resetting thermal protection which is
activated if it over-heats. Switch off the machine and wait a few minutes, then switch it on
again.
WHERE TO USE CARPET
GB
pag. 5

Publicité

Table des Matières
loading

Table des Matières