English
Wear a safety hard hat where there is a danger
of head injuries from falling objects.
Dust (e. g., crystalline material from the object
being cut), fumes and smoke may be produced
while cutting - health hazard!
Always wear a dust mask if dust is generated.
If fumes or smoke are anticipated (e. g., when
cutting composite materials), wear respiratory
protection.
Wear sturdy protective gloves made
of a resistant material (e. g. leather).
STIHL can supply a comprehensive range of per‐
sonal protective equipment.
2.2
Transporting the machine
Always stop the engine.
Carry the device by the handlebar only – abra‐
sive wheel pointing to the rear – hot muffler away
from the body.
To avoid serious burn injuries, avoid touching hot
parts of the machine, especially the surface of
the muffler.
Never transport the engine-driven device with
attached abrasive wheel – risk of breakage!
By vehicle: When transporting in a vehicle, prop‐
erly secure your machine to prevent turnover,
damage and fuel spillage.
2.3
Refueling
Gasoline is highly flammable – keep
away from fire or flame – do not spill
any fuel – no smoking.
Always shut off the engine before refueling.
Do not fuel a hot engine – fuel may spill and
cause a fire.
Open the fuel cap carefully to allow any pressure
build-up in the tank to release slowly and avoid
fuel spillage.
Only refuel the machine in a well ventilated
place. If fuel has been spilled, immediately clean
the machine – do not allow your clothes to be
splashed with fuel. If that happens, change your
clothes at once.
Dust may collect on the engine unit. If dust gets
mixed with fuel – risk of fire. For this reason,
ensure that the dust is always removed.
4
2 Safety Precautions and Working Techniques
Check for fuel leakage! Never start
the engine if fuel has been spilled or
is leaking – Fatal burns may result!
2.3.1
Bayonet-type fuel cap
Never use a tool to open or close the bayonet-
type fuel cap. This could damage the cap and
cause fuel to leak out.
Close the bayonet-type fuel cap carefully after
refueling.
2.4
Cut-off machine, spindle bear‐
ing
Correct spindle bearings ensure the concentricity
and axial running of the diamond abrasive wheel
– if necessary, get it checked by an approved
dealer.
2.5
Abrasive cutting wheels
2.5.1
Selecting the abrasive cutting wheels
Abrasive cutting wheels must be approved for
freehand cutting. Do not use other cutting wheels
and attachments – risk of accident!
Abrasive cutting wheels are suitable for different
materials: Observe the identification of the abra‐
sive cutting wheels.
STIHL generally recommends wet cutting.
Observe the outer diameter of the
abrasive wheel.
Spindle hole diameter of the abrasive
wheel and shaft of cut-off machine
must match.
Check the spindle hole for damage. Do not use
abrasive cutting wheels with a damaged spindle
hole – risk of accident!
0458-753-8221-D