Stihl TS 480i Notice D'emploi page 33

25 Maintenance and Repairs
24.4.1 TS 480i
Displacement:
Cylinder bore:
Piston stroke:
Engine power to ISO 7293: 3.9 kW (5.3 hp) at
Idle speed:
Max. spindle speed:
24.4.2 TS 500i
Displacement:
Cylinder bore:
Piston stroke:
Engine power to ISO 7293: 3.9 kW (5.3 hp) at
Idle speed:
Max. spindle speed:
24.5 Spark plug, fuel tank capacity
Spark plug (suppressed): Bosch WSR 6 F
Electrode gap:
Fuel tank capacity:
This spark ignition system meets all require‐
ments of the Canadian Interference-Causing
Equipment Standard CAN ICES-2/NMB-2.
24.6 Air filter
Main filter (paper filter) and flocked wire mesh
auxiliary filter
24.7 Weight
without fuel, without abrasive cutting wheel, with
electronic water control
TS 480i:
TS 500i:
24.8 Abrasive cutting wheels
The specified maximum permitted operating
speed of the abrasive cutting wheel must be
greater than or equal to the maximum spindle
speed of the cut-off machine used.
24.9 Abrasive cutting wheels (TS
480i)
Outside diameter:
Max. thickness:
Hole diameter/spindle diameter:
Tightening torque:
Composite resin abrasive cutting wheels
Minimum outside diameter of thrust
washers:
Maximum cutting depth:
Diamond abrasive cutting wheels
Minimum outside diameter of thrust
washers:
0458-753-8221-D
3
72.2cm
52 mm
34 mm
9300 1/min
2500 rpm
5350 rpm
3
72.2cm
52 mm
34 mm
9300 1/min
2500 rpm
5350 rpm
NGK BPMR 7 A
STIHL ZK C 14
0.5 mm
3
725 cm (0.725 l)
10.0 kg
10.2 kg
300 mm
3.5 mm
20 mm
30 Nm
103 mm
100 mm
103 mm
Maximum cutting depth:
24.10 Abrasive cutting wheels (TS
500i)
Outside diameter:
Max. thickness:
Hole diameter/spindle diameter:
Tightening torque:
Composite resin abrasive cutting wheels
Minimum outside diameter of thrust
washers:
Maximum cutting depth:
Diamond abrasive cutting wheels
Minimum outside diameter of thrust
washers:
Maximum cutting depth:
25 Maintenance and Repairs
Users of this machine may only carry out the
maintenance and service work described in this
user manual. All other repairs must be carried
out by a servicing dealer.
STIHL recommends that you have servicing and
repair work carried out exclusively by an author‐
ized STIHL servicing dealer. STIHL dealers are
regularly given the opportunity to attend training
courses and are supplied with the necessary
technical information.
When repairing the machine, only use replace‐
ment parts which have been approved by STIHL
for this power tool or are technically identical.
Only use high-quality replacement parts in order
to avoid the risk of accidents and damage to the
machine.
STIHL recommends the use of original STIHL
replacement parts.
Original STIHL parts can be identified by the
STIHL part number, the { logo and the
STIHL parts symbol K (the symbol may appear
alone on small parts).
26 Disposal
Contact the local authorities or your STIHL serv‐
icing dealer for information on disposal.
Improper disposal can be harmful to health and
pollute the environment.
English
100 mm
350 mm
4.5 mm
20 mm
30 Nm
103 mm
125 mm
103 mm
125 mm
33