OEG CPA-E 100 Serie Mode D'emploi page 44

44
9. Power settings and characteristics
Parameter
AUTO
(default
setting)
BL ( 1-9 )
HD ( 1-9 )
HS ( 1-9 )
Q ( 0-100% )
GB
Characteristic
Between highest
and lowest
proportional
pressure
characteristic
Proportional
pressure
characteristic
Constant
pressure
characteristic
Constant speed
characteristic
Flow rate
High-efficiency wet-running circulation pump with screwed or flanged connection
OEG CPA-E 100 series
Features
Automatically controls the pump within the set range.
Pump power is adapted based on the size of the system
and load change over a defined time.
In AUTO mode the pump operates with
proportional pressure control.
The operating point of the pump is on the
corresponding proportional pressure characteristic
depending on the required flow rate.
The operating point of the pump is on the
corresponding constant pressure characteristic.
The flow rate is constant.
The pump runs at constant speed.
The power depends on the submode (1.9).
The pump can be vented by setting the the power
to maximum (HS9) for a short time.
Indicates the flow rate during operation.