OEG CPA-E 100 Serie Mode D'emploi page 38

38
6. Control panel
6.1. Display and operating elements on the control panel
6.2. Error indication
When the pump is switched on, position 6 indicates the operating
status of the pump:
Speed indicator lights up continuously = pump is in operation
Speed indicator flashes = error in pump operation
Error display can be explained as follows:
Error code
Speed 1 flashes
Speed 2 flashes
Speed 3 flashes
Speed 4 flashes
Speed 5 flashes
Speed 5 flashes
Speed 7 flashes
Warning
Disconnect the pump from the power supply before you
remedy the rror. After the remedy, the pump can be con-
nected to the power supply again. Restart then.
GB
Description
Overvoltage
Undervoltage
Excessive motor current
Phase failure
Pump locked
Low load, no medium
Motor fault
High-efficiency wet-running circulation pump with screwed or flanged connection
OEG CPA-E 100 series
1. Display of flow rate during operation
2. Button to reduce the speed
3. Display of operating mode
4. Button for setting the operating
mode
5. Button to increase the speed
6. Speed indicator