KitchenAid KXU8036YSS Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

4. Repeat steps 1-3 for the underside of the top of the cabinet�
Cabinet cutouts
*From wall, not cabinet frame
Wall Venting Under Cabinet
To make a 3 / " x 10 / " (8.9 cm x 26.7 cm) rectangle in
1 1
2 2
the wall:
1. Make two lines by measuring 3/8" (9�5 mm) and 3
(9�8 cm) down from underside of cabinet and mark on the
centerline on the back wall�
2. Mark lines 5 / " (13�3 cm) to the right and left of the
1
4
centerline on the wall�
Use saber or keyhole saw to cut a rectangular opening in the
wall for the vent�
Cabinet
front
³⁄₈"
(0.9 cm)
3 ⁷⁄₈"
(9.8 cm)
3. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet� Mark on the
underside of cabinet the location of the four keyhole
mounting slots on the range hood� Set range hood aside on
a covered surface�
A
A. Keyhole slot
4. Use 1/8" (3�0 mm) drill bit and drill four pilot holes as
shown�
A. Drill pilot hole.
5. Install the 4 - 4�5 x 13 mm mounting screws in pilot
holes� Leave about 1/4" (6�4 cm) space between screw
heads and cabinet to slide range hood into place�
*¹⁄₂" (1.3 cm)
*4¹⁄₂"
5¹/₄"
(11.4 cm)
(13.3 cm)
5¹/₄"
(13.3 cm)
Centerline
5 " 5 "
¹⁄₄
¹⁄₄
(13.3 cm) (13.3 cm)
A
¹⁄₄"
(6.4 mm)
1. Determine and mark the centerline on the wall where the
canopy hood will be installed�
2. Select a mounting height between a minimum of 24"
(61�0 cm) for electric cooking surfaces and 30" (76�2 cm) for
gas cooking surfaces� The suggested maximum height is 36"
(91�4 cm) above the range to the bottom of the hood� Mark a
horizontal reference line on the wall�
3. Using two or more people, center the hood on the vertical
centerline, then align the bottom of the hood with the
horizontal reference line marked on the wall�
A
7 / "
8
4. Mark centers of the fastener locations to the wall� Set range
hood aside on a covered surface�
IMPORTANT: All screws must be installed into wood� If there
is no wood to screw into, additional wall framing supports
may be required�
5. Drill 3/16" (4�8 mm) pilot holes at all locations where screws
are being installed into wood�
6. Install the 4 - 5 x 45 mm mounting screws� Leave a 1/4"
(6�4 mm) gap between the wall and the back of the screw
head to slide range hood into place�
7. Determine and make all necessary cuts in the wall or ceiling
for the vent system� Install the vent system before installing
the hood� See the "Venting Requirements" section�
For Wall Installations:
B
X
D
A. Horizontal reference line
B. Vertical centerline
C. Mounting height
D. Cooking surface
A
A. Keyhole slot
A
A. Drill pilot hole.
¹⁄₄"
(6.4 mm)
C
9