Télécharger Imprimer la page

Mesto 6211 Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

Instructions for use
Instructions for use
Instructions for use
Instructions for use
Compressed air filler valve with pressure reducer
for MESTO FERRUM and RESISTENT compression sprayers
Models: No. 6211 A with automobile tyre valve connector
No. 6211 B with quick-snap coupling NW 7,2
The pressure reducer can be adjusted continuously between
0 bar = Adjusting wheel turned fully to the left (flow shut off!)
and
6 bar = Adjusting wheel turned fully to the right
When pumping, pay attention to the pressure gauge on the sprayer tank and the highest pressure allowed for
the tank. When beginning to fill, check that the safety valve on the tank functions perfectly by pulling up the red
pin for this purpose. If the spray tank is to remain connected with the compressed air supply line during the
spraying operation, it is recommendable to limit the working pressure in the tank to the optimum spraying
pressure of the spray nozzle (1,5 - 4 bar depending on the type of nozzle, see the Instructions for the use of the
sprayer). Liquid removed from the tank is replaced by air from the air supply line and the spray pressure
remains constant.
Always begin to regulate the working pressure from the lowest setting of the pressure reducer by starting at the
left and turning the adjusting wheel slowly to the right during filling.
Safety requirements :
Maximum allowable pressure:
Compressed air supply line
Working pressure (pressure reducer outlet)
Changes on the pressure reducer are not allowed under no circumstances. If malfunctions occur, take the air
filler valve out of operation and have it repaired and readjusted.
Before using the sprayer, check the condition of the tank inside and outside (no leaks, no corrosion, no
deformations) and of all other parts. Make sure that the screw threads on the air filler valve as well as on the
tank are in order and tight.
Accessory (option) :
No. 6246
Quick-snap type coupling, self-closing, with male thread R 1/4"
(as adapter to other connector systems, only for No. 6211 B)
6093440
No. 6211
10 bar
6 bar
- 2 -
0219

Publicité

loading