Pando PI DOM Manuel D'installation page 87

INOXPAN S.L.
T o stop the cooking time:
•
A ction
Select the Timer
Stop the time
If several timers are activated, repeat the process.
E gg timer function:
•
Egg timer is an independent function. It stops as soon as a heating zone starts working.
When the hob is switched off, the timer continues until it has reached the selected time.
A ction
Activate the hob
Select the Timer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops blinking.
The time is confirmed and the timer starts.
Automatic stop at the end of the cooking time:
•
As soon as the selected cooking time has finished, the timer display is blinking [ 000 ] and a sound
rings.
To stop the sound and the blinking, press the key [ - ] and [ + ].
Automatic cooking
All the cooking zones are equipped with an automatic cooking device. The cooking zone starts at
full power for a certain amount of time, then automatically reduces its power until it reaches the
pre-selected power level.
S tart-up:
•
A ction
Power level selection
(for example « 7 »)
S witching off the automatic cooking:
•
A ction
Power level selection
Stop&Go function
This function temporarily puts an end to the hob's entire cooking activity, and allows restarting
with the same settings.
S tart up/stop the stop&go function:
•
A ction
Engage stop&go
Stop stop&go
C ontrol panel
Press simultaneously key [ - ] and [ + ] Timer display on
of the timer until the
desired display is on
Press key [ - ] of the timer
C ontrol panel
press display [ ]
Press simultaneously key [ - ] and [ + ]
of the timer
Press key [ - ] of the timer
Press key [ + ] of the timer
C ontrol panel
slide on the "SLIDER" to [ 7 ]
and stay 3s
C ontrol panel
slide on the "SLIDER"
C ontrol panel
press [ II ]
press [ II ]
Press on the animated "slider"
11
Display
[ 000 ]
Display
[ 0 ]
[ 000 ]
[ 60 ] to 59, 58...
Time increase
Display
[ 7 ] is blinking with [ A ]
Display
[ 0 ] to [ 9 ]
Display
[ II ] and control light on
"Slider" animated
previous settings
EN