Publicité
Les langues disponibles
Les langues disponibles
INOXPAN S.L.
Residual heat indication
After the switch off of a heating zone or the complete stop of the hob, the heating zones are still
hot and the symbol [ H ] indicates this on the display.
The symbol [ H ] disappears when the heating zones can be touched without danger.
Do not touch the heating zones and do not put any heat sensitive objects on them, as long as the
residual heat indicators are switched on. There are risks of burns and fire.
Booster and Double Booster function
Booster [ P ] and Double Booster[
When this function is activated, the heating zones work during 10 minutes at an ultra- high speed.
This is meant to be used for heating up big quantities of water very quickly (for e.g. pasta).
Start up / Stop the Booster:
•
A ction
Start up the Booster
Stop the Booster
Start up / Stop Double Booster:
•
A ction
Start up Booster
Start up Double Booster
Stop Double Booster
Stop Booster
•
Power management:
The whole cooking hob is equipped with a maximum potential. When the Booster function is
activated, the electronic system automatically orders to reduce the power level of another heating
zone, in order to avoid exceeding the maximum potential. The display blinks [ 9 ] during a few
seconds, then shows the maximum of power allowed :
H eating zone selected
[ P ] is displayed
Timer
The timer can be used simultaneously with all the heating zones, and this with different time
settings (from 1 to 999 minutes) for each heating zone.
Setting and modification of the cooking time :
•
A ction
Select the power level
Select the timer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops blinking.
The time is confirmed and the timer starts.
] grant a boost to the selected heating zone.
C ontrol panel
Slide to the end of the "SLIDER"
Or press directly on the "B"
Slide on the "SLIDER"
C ontrol panel
Slide to the end of the "SLIDER"
Or press directly on the "B"
Re-press key [ B ]
Slide on the "SLIDER"
Slide on the "SLIDER"
Other heating zone:(example: Booster level 9)
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
C ontrol panel
slide on the "SLIDER"
Press simultaneously key [ - ] and [ + ] Timer display on
of the timer until the
desired display is on
Press key [ - ] of the timer
Press key [ + ] of the timer
10
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[
and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase
EN
Publicité
