Technical Data; Maintenance; Changing The Oil; Air Filter - Einhell Royal RBP 35 SPK1 Instructions De Montage Et Mode D'emploi

Anleitung RBP 35_SPK1:_

7. Technical data

Engine type: 4-stroke engine; air-cooled
Max. engine output:
Displacement:
Idle speed of engine:
Maximum engine speed:
Fuel:
Tank capacity:
Oil volume / type:
Spark plug:
Max. intake head:
Max. delivery head:
Max. pressure:
Max. pumping rate:
Weight (with empty tank):
Intake/Discharge connector:
2"/1.25"/1" thread connector
L sound power level:
WA
L sound pressure level:
pA

8. Maintenance

In this connection, please also read the attached
service information

8.1 Changing the oil

The engine oil is best changed when the engine is at
working temperature
Use only engine oil (10W30).
Place the machine on a slightly inclined surface
so that the oil drain plug is at the lower end
(Figure 5a / Item A).
Remove the oil filler screw (Figure 5a / Item B).
Remove the oil drain plug and drain the warm en-
gine oil into a suitable container.
After all the oil has drained, screw in the oil drain
plug and place the machine on a flat surface.
Insert fresh engine oil up to the top mark on the
oil dipstick (Figure 5b / Item H). Important. Only
inset the oil dipstick to check the oil level. Do not
screw it in.
While the machine is working, the oil level must be
between the two marks "L" and "H" (Figure 5b).
Dispose of the waste oil properly.
12.09.2007 9:47 Uhr Seite 13

8.2 Air filter

Clean the air filter at regular intervals, and replace it if
necessary.
Remove the screw from the air filter cover (Figure
4.8 kW / 6.5 bhp
6a)
Remove the air filter cover.
196 ccm
Remove the screw from the air filter element (Fig-
3600 rpm
ure 6b)
4000 rpm
Remove the air filter element (Figure 6c).
Regular unleaded petrol
Clean the air filter by tapping it, blowing it out
3.6 l with compressed air or by washing it with soap
suds. Important. Leave the air filter to dry before
600 ml / 10W30
you refit it.
F7TC
Assemble in reverse order.
6 m
26 m
8.3 Spark plug
Clean the spark plug at regular intervals, and replace
2.6 bar
it if necessary. Set the electrode gap to 0.6 mm.
35000 l/h
Remove the spark plug boot by twisting it (Figure
28 kg
7)
2" hose connection Remove the spark plug using a spark plug
wrench
Clean the spark plug with a copper wire brush or
95 dB
fit a new one.
75 dB
Assemble in reverse order.

9. Storage

Rinse the pump thoroughly with water before
lengthy periods of inactivity or winter storage.
Close the petrol cock and allow the engine to run
until it stops to empty the carburetor.
Fill the tank fully to prevent rust formation.
Remove the drain plug (Figure 3 / Item 12) and
fully drain the pump housing.
Store the machine in a dry place out of the reach
of children.

10. Ordering replacement parts

Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
13