Kozy Heat Fireplaces Komfort Zone KZK-1510A Mode D'emploi page 41

4.3 Callaway See Thru
All contents in this kit are required and must be installed.
The Kozy Zone Kit requires that the convection baffle, lo-
cated above the firebox inside the appliance metal cabinet,
to be removed to allow the hot airflow to convect upwards
into the air ducts installed on the fireplace. You will also
remove the cover plates.
See additional requirements and installation information in
the appliance manual.
1. Remove the convection baffle from the appliance. Re-
cycle this panel as it is no longer needed. The (6)
baffles are secured by (2) screws each behind the up-
per edge of both fireplace openings. Each side of the
fireplace has (3) convection baffles to be removed. See
FIGURE 4.10.
2. Remove (4) cover plates on top of the appliance (4
screws each).
3. Assemble fireplace stand-off assembly.
4. Align the take off collars to the corresponding holes on
top of the appliance. Secure with screws previously
removed. Install the take off collars to the correspond-
ing opening(s) on the plenum(s). Use supplied screws.
Figure 4.10 - Callaway ST Convection Baffle Removal (3
baffle pieces on each side of the fireplace)
KZK-1510A
Figure 4.11 - Callaway ST Cover Plate Removal
Figure 4.12 - Callaway ST Air Flow with Convection
Baffles Removed
41 Rev. 10 — May 2023