WAGNER W 500 Manuel D'instructions page 36

GB
2) Place on the valve cover (Fig. 12, 2) and screw it closed.
3) Place the ventilating hose (Fig. 12, 1) on the valve cover and on the nipple at the gun
body.
4) Push the nozzle seal (fig. 14, 6) over the needle (7); the groove (slot) should point
towards you.
5) Place the nozzle (fig. 14, 5) on to the gun body with the recess facing downwards.
Attention: Position of needle must be congruent with the nozzle aperture.
(Fig.15)
6) Put the air screen (fig. 16, 4) in the air cap (3). Put both on the nozzle (5) and secure
with the union nut (2).
7) Adjust the setting ring (fig. 17, 1) so that the two "horns" grip the air cap and the red
adjustment lever rests on the pin.
8) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
9) Insert the suction tube with container seal in the gun body.
18. Maintenance
WARNING! Never operate the machine without the air filter; dirt could be sucked
in and interfere with the function of the machine.
Disconnect plug before changing parts.
•
Change the air filter if it is soiled.
•
Remove air filter cover. (Fig. 18, a)
•
Insert a new air filter into the compartment.
•
Replace the cover on the unit until it latches.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part (Fig. 19, 7).
19. Spare Parts
Pos. Name
1 Wall Extra I-Spray spray attachment incl. 1800 ml container
2 Spray jet adjustment ring
3 Union nut
4 Air cap
5 Air screen
6 Nozzle
7 Nozzle seal (2 pcs.)
8 O-ring
9 Ventilating hose, valve cover, diaphragm
10 Container seal
28
Spare Parts List (Fig. 19)
W 500
Order No.
2363 207
2363 258
2353 698
2362 885
2362 886
2328 908
2304 433
2362 875
2304 027
2328 919