Publicité
Les langues disponibles
Les langues disponibles
GB
Use the red adjustment lever to also switch between a wide ( )
and a narrow (
) spray jet.
14. Adjusting the Material Volume (Fig. 8)
Set the material volume by turning the regulator on the trigger guard of the spray gun
-
turn to the left
+
turn to the right
An average flow setting provides the best result for most wall paints.
i
15. Spray Technique
•
Cover all surfaces not to be sprayed.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important: Start at the edge of the area to be sprayed. Start the spray movement
first of all, and then press the trigger. Avoid interruptions within the area
to be sprayed.
The spray movement should come from the arm, not just from the wrist. This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation. Select a distance of 20-30 cm, depending on the desired
spray jet width.
Fig. 9 a:
CORRECT Even distance to the object.
Fig. 9 b:
INCORRECT An uneven distance will result in uneven paint application.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
•
If nozzle and air cap are soiled, clean both parts with water and solvent.
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 10).
Interior wall paint in strong colour shades should be applied at least twice
i
(allow first paint coat to dry first). This will ensure good coverage.
26
lower material volume
higher material volume
W 500
Publicité
