Cleaning - Atag WU50 BM Mode D'emploi

MAINTENANCE

Cleaning

EN 8
Note! Before each servicing, first disconnect the cooker hood by
removing the plug from the wall socket or by switching off the main switch
of the residence. The hood must be cleaned regularly, both inside as
well as outside (with at least the same regularity as used for cleaning the
grease filters). Do not use any products that contain abrasive materials.
Do not use alcohol!
Note! If you do not follow these instructions with regards to the
cleaning of the appliance and the cleaning or replacement of the filters,
this can lead to fire. It is essential to follow these instructions!
The manufacturer is not liable for damage to the motor or damage
as a result of fire that is due to improper servicing or not following
the above safety requirements.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth. Then treat
with clean water. Do not use any aggressive cleaning agents such as
soda. The lacquer of the cooker hood will remain in good condition if
you rub the lacquer with wax once in a while.
Metal grease filters
Metal filters must be cleaned once per month (or when the filter cleaning
indicator – if present on the model – specifies this). Clean the filters
with neutral cleaning agents, by hand or in the dishwasher at low
temperatures and with a short programme. Place the grease filters in the
dishwasher with the openings facing down so that water can run out.
Aluminium grease filters will become dull from the cleaning agents in the
dishwasher. This is normal and does not affect the working of the filters.
The saturation of the filter depends on the intensity of use, the manner
of cooking and the regularity with which the grease filters are cleaned.