Maintenance; Cleaning The Hood; Cleaning The Grease Collector - Atag WS9011EVM Notice D'utilisation

MAINTENANCE

Cleaning the hood

Attention!
For all maintenance first switch off the mains power to the cooker hood by pulling the
plug out of the socket or by turning off the home's master switch.
The hood needs to be cleaned regularly, both inside as well as outside. Do not use
abrasive cleaners. Do not use alcohol!
Attention!
If the instructions regarding cleaning the appliance or replacing the filters are not followed,
this can cause a fire. These instructions should be followed! The manufacturer is not liable
for damage to the hood or fire damage resulting from incompetent maintenance or from
non-adherence to the recommendations above and delivered safety instructions.
Clean the hood with soapy water and a soft cloth. Then wash off with clean water. Do not use
aggressive cleaning agents such as caustic soda and do not use scouring pads. Finish with a
non-abrasive, non-polishing agent and buff the stainless steel in the direction of the grain.

Cleaning the grease collector

Attention!
Make sure the hood is completely switched off!
1. Hold the service tool at the handle, put it into the hole in the middle of the grease collector
and tighten the tool by turning it to the right.
EN 9