Cleaning Filters - Atag ES10211SAM Notice D'utilisation

USE

Cleaning filters

EN 8
Saturation grease and carbon filters
The filters should be replaced or cleaned when the grease filter
indicator (4) or the carbon filter indicator (3) are lit.
Grease filter
The grease filter indicator (4) will flash after 30 operating hours.
• The grease filters should then be cleaned.
• Reset the memory by pressing and holding the '-' button (2) until
the grease filter indicator (4) stops flashing.
Carbon filter
The carbon filter indicator (3) will flash after 120 operating hours.
• The carbon filter should then be cleaned or replaced.
• Reset the memory by simultaneously pressing and holding the '-' (2)
and '+' (8) buttons until the carbon filter indicator (3) stops flashing.
Switching on carbon filter indicator
• Simultaneously press and hold the '+' (8) button and the lighting
button (1) until the carbon filter indicator (3) flashes twice.
The carbon filter indicator is activated.
Switching off carbon filter indicator
• Simultaneously press and hold the '+' (8) button and the lighting
button (1) until the carbon filter indicator (3) flashes once.
The carbon filter indicator is switched on:
• The carbon filter indicator (3) lights up for 3 seconds.
The carbon filter indicator is switched off:
• The carbon filter indicator (3) flashes for 3 seconds.