Cleaning - Atag WO61 BM Serie Mode D'emploi Et Instructions D'installation

maintenance

cleaning

hood
attention! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse. Or if the
appliance has been connected through a plug and socket,
then the plug must be removed from the socket.
enamelled extractor hoods
Clean the extractor hood with soap and a soft cloth. Then
rinse with clean water. Do not use aggressive cleaning
agents, such as soda. The enamel will remain attractive if you
polish it with wax from time to time.
stainless steel extractor hoods
For cleaning the stainless steel parts you can best use a mild
cleaning agent (washing-up liquid) and a damp cloth. Dry with
kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
ATAG supplies cleaning and maintenance agents for extractor
hoods. For information on availability, please contact the
consumer department (see warranty conditions for the phone
numbers).
Never use abrasive cleaning agents (such as green scourers
or other scouring pads) or polishing cleaning agents (such as
liquid abrasives). Never use caustic agents. These can attack
the stainless steel.
GB 7