Publicité
FRONT BRAKE ADJUSTMENT
EC362040
FRONT BRAKE ADJUSTMENT
3-18
NOTE:
If bleeding is difficult, it may be necessary
to let the brake fluid system stabilize for a
few hours. Repeat the bleeding procedure
when the tiny bubbles in the system have
disappeared.
j. Add brake fluid to the level line on the
reservoir.
w
Check the operation of the brake after
bleeding the brake system.
3. Install:
9Protector (rear brake)
9Diaphragm
9Master cylinder cap
1. Check:
9Brake lever position a
Brake lever position a a :
Standard position
95 mm (3.74 in)
2. Adjust:
9Brake lever position
Brake lever position adjustment steps:
9Loosen the locknut 1.
9Turn the adjusting bolt 2 until the lever
position a is within specified position.
9Tighten the locknut.
Locknut:
5 Nm (0.5 m•kg, 3.6 ft•lb)
cC
Be sure to tighten the locknut, as it will
cause poor brake performance.
INSP
ADJ
Extent of adjutment
76 ~ 97 mm
(2.99 ~ 3.82 in)
Publicité
