Abus RWM300 Manuel D'utilisation Et D'installation page 28

e) The adhesive bond will reach its
ultimate strength after approx.
72 hours.
2. Drilled hole mounting
Application:
a) Using an 8-mm drill bit, drill a
hole at the installation position
(take care not to strike any electric
cables, etc. !)
b) Insert the 8-mm dowel into the
hole.
c) Push the supplied 5-mm counter-
sunk screw through the bottom of
the magnetic holder and into the
perforated hole (Fig. 4).
d) Tighten the screw into the dowel
so that the screw sits flush and is
fully sunk into the recess provided
for it in the magnetic holder.
e) Only tighten the screw enough to
prevent the magnetic holder from
deforming or bending.
f) Place the device on the magnetic
holder.
g) If required, the device can be remo-
ved from the magnetic holder by
pulling it gently in a vertical
motion.
MoAnltg RWM 300_DE_GB_FR_NL_IT_150716.indd 28
GENERAL SAFETY GUIDELINES
Smoke alarms are designed to help
you detect fire in good time. However,
they cannot extinguish a fire nor pre-
vent it starting, nor can they notify
the fire brigade. When danger is detec-
ted by the presence of combustion
gases, smoke alarms emit a loud alarm
sound to inform you of the danger.
Despite great care in the manufacture
of smoke alarms, it is also possible
that a fault may occur that prevents
the device from warning of a potential
fire, or from doing so in good time !
The usual precautions in relation to
fire, flammable materials and techni-
cal equipment must always be obser-
ved ! Please do not expose the device
to direct sunlight or extreme heat,
because it could damage the built-in
battery.
– 28 –
Fig. 4
16.07.15 14:32