Abus RWM300 Manuel D'utilisation Et D'installation page 26

ASSEMBLY
The smoke alarm is held in place by
a magnetic holder attached to the
mounting site. Please note that the
magnetic holder only has a strong
magnetically attractive force from one
direction. The magnetic holder may
either be mounted by an adhesive
fixing or by drilled holes:
1. Adhesive mounting
1.1 Adhesive mounting with fasteners
Magnetic holder, self-adhesive
coated in accordance with
EN14604:2005/AC:2008
Warning: The sole use of this self-
adhesive fastener produces a
• very maintenance-friendly.
• stable.
• magnetic connection of the device
to the installation site.
• The device can be detached from
the magnetic holder by gently
pulling it downwards e.g. for
inspection, maintenance or
cleaning.
MoAnltg RWM 300_DE_GB_FR_NL_IT_150716.indd 26
For this adhesive mounting, only the
supplied adhesivemay be used.
The assembly site must be
• firm
• dry
• free of dust, grease or loose paint,
etc.
Application:
a) Remove the information sticker and
the protective film from the applied
adhesive material (Fig. 3) on the
magnetic holder.
b) Press the adhesive surface of the
magnetic holder firmly onto the
mounting surface for approx.
10 seconds.
c) Place the device on the magnetic
holder.
d) The adhesive bond will reach its
ultimate strength after approx.
72 hours.
g) If required, the device can be remo-
ved from the magnetic holder by
pulling it gently in a vertical motion.
– 26 –
Fig.. 3
16.07.15 14:32