EUROM Safe-T-Fanheater 2000 LCD Manuel D'utilisation page 34

temperature drops below the set temperature, the heater will once again blow
out hot air.
In order to set a specific time with the timer, press the timer buttons (2) when

the heater is on. Symbol 15 (usually set to 00) will begin to blink and you can
now use the + and - buttons to set and/or adjust the
functional period (from 0 to 24 hours). Every time
you press the button the set period is increased or
decreased by one hour. By pressing the timber
button again, you confirm the setting and it will stop
blinking. The heater will now function for the set
period and then automatically switch off.
Pressing on the on/off button will switch the heater

off. Press the main switch again (O) and remove the
plug from the socket.
Safety features
Tipping safeguard
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch if off,
unplug and check for damage. Do not use the heater if it is damaged or
malfunctioning, but have it inspected/repaired!
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater
off. This may occur if the heater cannot give off enough heat or if it cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. When the overheating safeguard
switches the heater off, set the main switch to '0' (off), unplug and allow the heater
to cool down. Remove and/or amend the cause of overheating and reuse the heater
as normal. If you cannot find a cause and overheating recurs, stop using the
heater, and take it in for inspection/repair.
Cleaning and maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common
cause of overheating so these should be removed regularly. Switch off the heater,
remove the plug from the socket and allow the heater to cool down before cleaning
or carrying out maintenance work.
 Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do
not use aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or
chemical solutions!
34