EUROM Safe-T-Fanheater 2000 LCD Manuel D'utilisation page 33

Remote panel control and remote control
1. ON/OFF button
2. Timer button
3. High/low output button
4. Temperature & duration higher
5. Temperature & duration lower
6. Symbol high/low output active
7. Output set at 1000W
8. Output set at 2000W
Set-up and Operation
Set the main switch (back) to I (on). You can now operate the heater with

buttons 1 to 5 on the control panel or the remote control.
Press once on the on/off button (1); the heater will start to work and the LCD

screen will light up.
By pressing once or twice on the high/low output button, you can select the low

(1000W) or high (2000W) setting, respectively. Symbol 7 or 8 indicates this. If
the room temperature is under the set temperature, the heater will heat at
1000 or 2000W. As the heater is heating, symbol 6 will blink: half for 1000W,
full for 2000W.
Set the desired temperature by pressing buttons 4 (higher) or 5 (lower).

Symbol 12 will blink for a few seconds to indicate the set temperature; symbol
9 and 10 will blink too. After a few seconds, the 9 will go out and the display
(12) will once again show the ambient temperature. The temperature can be set
to between 15 and 45°C. If the set temperature is lower than the ambient
temperature, the heater will stop heating and just ventilate. When the ambient
9. Symbol 'temperature is set'
(SET)
10. Symbol 'temperature' (TEMP)
11. Symbol '°C'
12. Display of set and room
13. Symbol 'timer active' (TIMER)
14. Symbol 'timer on display' (H)
15. Set functional duration
33
temperature