Changing The Carbon Brushes; Cleaning; Disposal - Zipper Maschinen ZI-ABH1500D Manuel D'utilisation

13.2 Changing the carbon brushes

If the carbon brushes are worn down to the wear limit may result in engine damage. Both carbon
brushes should be replaced together. The procedure is ident in both models.
Loosen the screws of the cover M4X12.
•
Take off the cover and unscrew the brush cap.
•
Remove the carbon
•
After replacing the carbon brushes rotate the brush cap back on.
•
Screw the cover back on.
•

13.3 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution

13.4 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
ZIPPER MASCHINEN GmbH
ZI-ABH1500D / ZI-ABH1700D
brushes.
www.Zipper-Maschinen.at
N O T I C E
31