Start Up; Checking The Engine Oil Level; Refuel - Zipper Maschinen ZI-RD300 Mode D'emploi

28.3

Start up

28.3.1 Checking the engine oil level

ATTENTION! For transport motor oil has been drained. Fill up with 4-stroke quality
motor oil before first operation! Failure to do so will result in permanent motor
damage and void guarantee!
A too low oil level will cause damage to the engine and shorten the service life of the
machine. Therefore, check the motor oil level before every start and if necessary fill
up with oil.

28.3.2 Refuel

Use only unleaded fuel with min. 95 octane or higher
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RD300
W A R N I N G
1. To check the engine oil level, place the machine on a flat, level
surface. Switch off the motor and wait for ten minutes to allow
the circulating oil to collect in the oil pan.
2. Unscrew the oil-dipstick and wipe with a clean, lint-free cloth or a
non-fibrous paper towel.
3. Push the dipstick back into the opening as far as possible, but do
not screw it in. (Make sure that the dipstick is really pushed in
completely - occasionally it gets jammed).
4. Pull out the oil dipstick again and check the oil level. There are
two markings for this - see illustration on the left.
5. If the oil level is low, fill up the recommended oil to the upper rim
at the maximum (maximum filling volume: see technical data:
do not overfill!)
6. Insert the oil dipstick again and retighten it.
7. Wipe away oil residues.
W A R N I N G
1. Refuelling only outdoors!
2. Before removing the filler cap, turn the engine off and let it
cool machine
3. Clean the fuel filler cap area
4. Remove the filler cap carefully
5. Fill in fuel
6. Fuel tank capacity: 3,6 l. Fill tank only up to 1,5 cm below the
rim of the filler neck, so that the fuel has place for expansion.
7. Replace and tighten the filler cap
8. Wipe any fuel residues and wait until it evaporates
NOTICE
OPERATION
32