Operation; Insert Chisel; Switch On - Zipper Maschinen ZI-ABH1500D Manuel D'utilisation

12.2 Operation

12.2.1 Insert chisel

Clean the tool shank of deposits and grease it lightly one.
The clamp bolt from the tool shaft pull and turn 90 ° clockwise
•
Set the tool and rotate the clamp bolt back to 90 degrees and
•
let it snap back into the tool shank.
Check by pulling the tool if the tool is firmly held in place.
•
Tool shank should always be greased before insertion.
•
When removing the tool. Follow the above procedure in reverse
•
order.

12.2.2 Switch on

Press the Power push button to the start the engine and set the stroke to move.
•
By pressing the locking button can be switched to continuous operation.
•
ZIPPER MASCHINEN GmbH
ZI-ABH1500D / ZI-ABH1700D
www.Zipper-Maschinen.at 28