arjo MAA2070M Mode D'emploi page 8

MAA4050M
MAA4100M
MFA1000M
EN
Clip Attachment & Detachment
NOTE
If available on your lift device, reposition the
spreader bar using the Dynamic Position
sling. See lift IFU for instructions.
Attach the Clips (5 steps)
Make sure the lug is locked at the top end of the
Applying the Sling
In Bed (22 steps)
Apply bed brakes and adjust the height of the bed
WARNING
To avoid injury during log roll, make sure
there is another caregiver present and/or
use the side rails on the opposite side of
the bed.
Fig. 3
– S, M, L, LL
S S, M, L, LL
– M, L, LL
S S, M, L, LL
Detach the Clips (3 steps)
Make sure that the weight of the patient is taken up by
(See Fig. 3 )
Fig. 4
8
S, M, L, S, L, LL,
S, M, L
LL, XL XL, XXL
S, M, L, L, LL,
S, M, L
LL, XL XL, XXL
M, L, LL,
L, LL, XL M, L
XL
S, M, L, L, LL,
S, M, L
LL, XL XL, XXL
(See Fig. 4 )
Make sure the strap is not squeezed in between the
(See Fig. 5 )
Make sure the lug is unlocked at the bottom of the
roll is not possible, use an Arjo sliding sheet/tube
tube IFU
sure that the centre line is aligned with the patient's
(See Fig. 6 )
Continue with the steps on the next page.
Fig. 5
S, M, L, LL, XL
S, M, L, LL, XL
M, L, LL, XL
S, M, L, LL, XL
Sliding sheet/
Fig. 6