Publicité
Les langues disponibles
Les langues disponibles
EXT: Alarm output continues until the ALARM RESET
button is pressed or the external alarm recover sig-
nal is received from the ALARM port.
The factory default setting is 2S.
Alarm Buzzer Setting
This item lets you select the ringing duration of the built-in
alarm buzzer when an alarm is activated.
1. Move the cursor to the ALARM BUZZER parameter in
the ALARM SETUP menu by pressing the D or C but-
ton.
2. Select the desired duration by pressing the + or -
button.
OFF: Disables alarm buzzer, regardless of an incoming
alarm.
1S - 30S, 40S, 50S, 1M - 5M: Selects an alarm duration
between 1 second and 5 minutes.
EXT: Alarm buzzer continues to beep until the ALARM
RESET button is pressed or the external alarm
recover signal is received from the ALARM port.
The factory default setting is 2S.
Video Loss Alarm Setting
This item lets you enable or disable the video loss alarm
function when the Disk Recorder detects the interruption of
the video signal.
1. Move the cursor to the VIDEO LOSS parameter in the
ALARM SETUP menu by pressing the D or C button.
2. Select either ON or OFF by pressing the + or - but-
ton.
ON: Enables the video loss function.
OFF: Disables the video loss function.
The factory default setting is ON.
Video Motion Detector Setting
The following settings are available when the Motion
Detector Board (Optional) is installed.
This item lets you enable or disable the motion detector
function when the Disk Recorder detects a motion on the
video image.
1. Move the cursor to the VIDEO MOTION DETECTION
parameter in the ALARM SETUP menu by pressing the
D or C button.
2. Select either ON or OFF by pressing the + or - but-
ton.
ON: Enables the motion detector function.
OFF: Disables the motion detector function.
The factory default setting is OFF.
3. Move the cursor to VMD AREA SETUP in the ALARM
SETUP menu by pressing the D or C button, then
press the SET button.
The VMD AREA SETUP table shown below appears on
the monitor screen.
6-2 VMD AREA SETUP
CAM SENSITIVITY
1
* OFF
2
* OFF
3
* OFF
4
* OFF
5
* OFF
6
* OFF
7
* OFF
8
* OFF
4. Move the cursor to the sensitivity editing area for the
camera by pressing the A, B, D or C button, then
select the desired mode by pressing the + or - but-
ton.
OFF: Disables the motion detector function.
LOW: Selects lower sensitivity.
MID: Selects normal sensitivity.
HIGH: Selects higher sensitivity.
The factory default setting is OFF.
5. If the parameter is set to something other than OFF in
step 4, press the SET button.
The detecting area setting window as shown below
appears on the monitor.
1
AREA SET/ERASE:PRESS[SET] AT CORNER
CAM SENSITIVITY
9
* OFF
10
* OFF
11
* OFF
12
* OFF
13
* OFF
14
* OFF
15
* OFF
16
* OFF
+
63
Publicité
