Panasonic WJ-HD500A Mode D'emploi page 15

Mounting into the Rack
The Disk Recorder can be mounted into the rack as
described below.
1. Remove the four rubber feet by removing the four
screws from the bottom of the Disk Recorder.
Remove 4 rubber feet
2. Place the rack mounting brackets on both sides of the
Disk Recorder and tighten with the four supplied
screws (M4 X10).
3. Install the Disk Recorder with the rack mounting brack-
ets in the rack, securing it with four screws (not includ-
ed).
Cautions:
• The cooling fan inside the Disk Recorder is subject to
wear and needs to be replaced periodically.
• Do not block the ventilation opening or slots in the
cover to prevent the appliance from overheating.
Always keep the temperature in the rack below 45°C
(113°F).
• If the rack is subject to vibration, secure the rear of the
appliance to the rack by using additional mounting
brackets (procured locally).
15