Publicité
Les langues disponibles
Les langues disponibles
maintenance
7
maINTeNaNCe
Before proceeding, follow the Pressure Relief
Procedure outlined previously in this manual.
Additionally, follow all other warnings to reduce
the risk of an injection injury, injury from moving
parts or electric shock. Always unplug the sprayer
before servicing!
7.1
DaIly maINTeNaNCe
Two daily procedures are required for routine operator
maintenance on this sprayer:
a. Lubricating the upper packings (section 7.2).
B. Cleaning the filter screen (section 6.4).
7.2
luBrICaTINg THe uPPer PaCkINgs
1. Clean out the paint that has seeped past the upper
packings into the packing oil reservoir (fig. 16, item 1)
above the fluid section.
2. Fill the packing oil reservoir 1/2 full with EasyGlide (P/N
0508619) supplied by the factory. This will extend packing
life.
Do not over-fill the reservoir so that it overflows
i
and drips into the paint.
22
7.3
maINTaININg THe fIlTer assemBly
i
CleaNINg (fIg. 17)
To clean the filter, perform the following procedure.
1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual.
2. Remove the filter cap assembly (1) and spring (2).
3. Pull the filter element with ball straight (3) out of the filter
body (4).
4. Clean inside the filter body, filter element with ball, and
filter cap assembly using the appropriate solvent.
1
i
Clean the filter regularly. Dirty or clogged filters
can greatly reduce filtering ability and cause
a number of system problems including poor
spray patterns, clogged spray tips, etc.
1
2
3
7
8
5
6
4
Use care in handling parts as dirt, debris,
scratches, or nicks may prevent o-rings or gaskets
from sealing.
This filter element filters from the inside out. Be
sure to clean the filter element thoroughly on the
inside. Soak in solvent to loosen hardened paint
or replace.
heavycoat
Publicité
