Bosch HDS8055C Manuel D'utilisation page 15

If the maintop is removed by a certified installer (for
example to check electrical or gas connection) the
panhead screws that were removed must be re-installed to
ensure proper functionality of burners.
Burner
Dual-flame burner
Small burner
Large burner
Checking burner cap placement
Check to make sure that there is no gap between the
burner cap and burner base.
See illustration for correct and incorrect placements of the
burner cap.
You may gently try to move the burner cap from side to
side to check if it is properly placed. If properly placed, the
cap will click from side to side as the prongs hit the groove
ridge.
Install grates
First position the outer grates, followed by the center
grate.
Burner cap dimensions
Inner dual: 1 3 / " (45 mm)
4
15
Ring: 5 / " (150 mm)
16
3
2 / " (55 mm)
16
15
3 / " (100 mm)
16
Familiarizing yourself with your appliance en-us
If you only have two grates, the order in which you position
them is not relevant.
Control panels
You can use the control panel to configure all functions of
your appliance and to obtain information about the
operating status.
Cooktop control panel
The cooktop has one control knob for each burner. Push
in and turn to the left to light and set the desired heat
setting. Once the flame appears, keep the knob pressed in
fully for 2-3 seconds before releasing and adjusting the
flame.
WARNING
Failure to operate knobs properly may result in personal
injury and damage to the appliance.
The cooktop has standard burner controls.
Symbol
off
min
max
Meaning
Cooking zone switched off
Minimum power
Maximum power
Inner flame switched on
15