Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical connection
Danger to life from electric
shock!
Switch power off.
DANGER
Device damaged by short
circuit!
Cut off the PE conductor and
CAUTION
any unused individual cores
and insulate them.
Strip the cable.
Only insert single cores in the device.
Connect the power cable as shown in the
wiring diagram on Page 12.
Adjust the potentiometer for TC and H
models. See also position "P" in Figure A.
ECA piano TC potentiometer "P":
Factory set overrun time
= approx. 6 minutes (9 o'clock)
ECA piano H potentiometer "P1":
Factory set overrun time
= approx. 12 minutes (12 o'clock)
ECA piano H potentiometer "P2":
Factory set humidity switching point
= approx. 70% (12 o'clock)
Press the motor cover [3] evenly and se-
curely into place on the device (see Fig. A).
All 5 locking hooks must clip into place.
Press the cover [4] evenly over the housing
[1] until it clicks into place. Do not bend or
distort it.
Commissioning
Check that the shutter [6] operates easily
and that it is undamaged.
Activate mains fuse.
Carry out a function test.
Dismantling
DANGER
First pull off the lower third of the cover [4]
and then remove it.
Release all 5 locking hooks (see arrow] on
the motor cover [3] from their positions
using a screwdriver.
Remove motor cover [3].
8. Maintenance
The device is maintenance-free.
– Subject to change –
Danger to life from electric
shock!
Switch power off.
GB
11
Publicité
Table des Matières
