Panasonic WX-SR202P Mode D'emploi page 44

Pairing
The microphone and the receiver must be paired to each other in order to establish a
connection.
Perform pairing when using a microphone which has not yet been paired to the receiver or
when a registration error occurs.
The maximum number of microphones which can be paired to a receiver and the maximum
number of microphones which can be used simultaneously is as follows.
When the maximum number of pairable microphones is exceeded, the newest microphone
will overwrite the oldest one.
Receiver
WX-SR202P 6 per channel
Refer to the microphone manual for further details on pairing devices.
⿟ Saving the pairing information for a paired microphone takes
Important approximately 10 seconds. Do not turn OFF the receiver immediately
(within approximately 10 seconds) after pairing a microphone. Pairing
cannot be completed if power is turned OFF.
■ Wireless pairing
Pair the devices through a wireless connection between a microphone and a wireless
antenna. Perform the pairing within the connection range of the wireless antenna connected
to the receiver.
1
Remove the battery cover of the microphone
Refer to the microphone manual for further details.
2
Set the receiver to pairing mode
Make sure that the [POWER] indicator on the receiver lights green, then press for at
least two seconds the [REG] button of the channel to which you want to pair a
microphone. When the wireless receiver is in pairing mode, the [REG] indicator of the
channel whose [REG] button has been pressed will blink orange. Pairing mode lasts
for 30 seconds, so pair the microphone within this time.
Power indicator
Receiver
44
Maximum number of pairable
microphones
Maximum number of simultaneously
usable microphones
2 (1 per channel)
Register indicator
Register button