Publicité
Les langues disponibles
Les langues disponibles
Do not install the product in the following places
Places exposed to direct sunlight or hot air currents
Places exposed to large amounts of humidity and/or dust
Places with a lot of condensation, subject to extreme temperature variation, or with very
high humidity
Places with large amounts of steam or grease, such as kitchens
Near speakers, TVs, magnets, and other strong magnetic sources
Inclined surfaces
Where there is a risk of damage from seawater or corrosive gases
Places where the product, the cables, etc. could easily be damaged
When installing in a rack
When installing the receiver in a rack, use one of those listed on "Installing in a rack"
(page 23).
Make sure that the temperature of the rack does not exceed +45 °C (113 °F). Not doing
so damages the inner components of the receiver and causes it to malfunction.
Place the receiver as far down on the rack as possible.
Power specifications
The product uses AC 120 V (60 Hz) power. Connect the product to an enough capacity
power source.
Power
Turning the power switch to OFF will turn the product OFF but it will not interrupt the flow
of current. Connect the power cord through a power breaking device in one of the
following ways in order to be able to easily switch it OFF.
Install the product near the electric outlet or breaker, and connect by the power plug.
Connect the product to a breaker panel with at least 3.00 mm (1/8 inches) of space
between contacts. Use a breaker which can cut off power from all poles except the
protective ground connection.
Static electricity
Before installing the product, discharge yourself by touching a grounded metal object in
order to avoid damage caused by static electricity buildup.
Tightening screws
Tighten screws straight up. After tightening the screws, make visual confirmation that
they are straight and well-tightened.
Do not use impact screwdrivers or electric screwdrivers, as even the ones with clutches
make it difficult to control the torque, and risk damaging the mounting unit.
21
Publicité
