Panasonic WX-SR202P Mode D'emploi page 39

Configuration switches
numbers
No.3 No.4
OFF OFF
OFF ON
ON OFF
ON ON
⿟ Changes in the configuration switches are applied during the start-
Important up of the receiver. If you have performed any changes while the
receiver was ON, turn the power switch OFF and ON again to restart
the product.
⿟ When wireless synchronization is enabled, the antenna connected
to the [ANTENNA 1] connector on a receiver becomes the reference
antenna for that system (receiver).
⿟ The reference antenna of the main system will be used as the
reference for wireless synchronization with other systems.
When there is no antenna connected to the [ANTENNA 1] connector
on a receiver, that receiver will operate in stand-alone mode and will
not be able to perform wireless synchronization with other systems.
⿟ The reference antenna of the sub-systems will be used for detecting
main system. When a system set to "sub-system" is turned ON, it will
search for main systems within the range of its reference antenna,
and, if it finds main system, it will start wireless synchronization and
will try to stay synchronized as long as possible.
When a system set to "sub-system" is turned ON and cannot find a
main system within its range, it will operate in stand-alone mode and
will not perform wireless synchronization. Also, if there is no antenna
connected to the [ANTENNA 1] connector on a receiver, that
receiver will operate in stand-alone mode and will not be able to
perform wireless synchronization with other systems.
Wireless synchronization settings
Stand-alone system (no wireless synchronization) (factory
default)
Stand-alone system (no wireless synchronization)
Sub-system (use wireless synchronization)
Main system
39