Panasonic WX-SR202P Mode D'emploi page 19

Rear
⑯
⑯ Network connector [100BASE-TX]
Connect a LAN cable (Cat 5 or higher; locally procured) to the PC with the support
software installed for configuration and maintenance.
⑰ Wireless antenna connectors [ANTENNA 1/2/3/4/5/6/7/8]
Ports used to connect the wireless antennas to the receiver.
Use LAN cables to connect the antennas. The antenna connected to [ANTENNA 1] will
be used as the reference antenna for wireless synchronization. (page 34)
⑱ Channel output connectors [CH OUT -10 dBV 600 Ω 1/2]
Individually outputs the audio from each channel.
WX-SR202P: 1/2
⑲ External input connector [AUDIO IN -10 dBV 600 Ω]
Takes external audio input to be mixed and sent to the mix output port.
⑳ Mix output connector [MIX OUT -10 dBV 600 Ω]
Outputs audio obtained by mixing the audio from each channel with the audio from the
[AUDIO IN] connector.
㉑ SIGNAL GND connector [SIGNAL GND]
Gathers the SIGNAL GND from external devices to eliminate electrical potential
difference.
㉒ Power cord
Connect the power cord to an AC 120 V 60 Hz power source.
⑰ ⑱ ⑲ ⑳ ㉑ ㉒
19