Télécharger Imprimer la page

Panasonic WX-SR202P Mode D'emploi page 20

Publicité

Les langues disponibles

Les langues disponibles

Installation
■ Installation precautions
Warning
When installing this product, follow all official ordinances on electrical equipment
technical standards.
This product is intended for indoor use only
⿟ It cannot be used outdoors.
Avoid exposing the product to direct sunlight for extended periods of time, and do not
install it near air conditioners or heaters. Failing to do so may lead to damage to the
shape and color of the product, and may cause it to malfunction. Also avoid exposure to
water droplets and bubbles.
Turn the product OFF to install it
⿟ Remove the power cord from the power socket before performing these operations. Also
turn OFF all mixers, amplifiers, and other devices connected to the receiver. Failing to
do so will result in a loud noise coming out of the speakers and possibly damaging the
system.
Installation place
⿟ This product produces a large amount of heat.
When installing product near a wall or ceiling, make sure it has at least 10 cm (3-15/16
inches) of clearance on all sides (see figure below).
At least
10 cm
(3-15/16 inches)
At least
10 cm
(3-15/16 inches)
⿟ Place the product on a flat surface. Do not place it upright with the rear surface facing
downward.
20
⿟ Always ask a retailer to perform these operations.
⿟ Before installation, set the power switch on the devices
you want to connect to OFF.
⿟ Carefully read the "Precautions" section and follow all of
its instructions. Also refer to the manual of the devices
you are connecting.
Wall
At least 10 cm
(3-15/16 inches)

Publicité

loading