Value Storage; Enabling/Disabling Stored Values; Displaying All Stored Values; Cancelling All Stored Values - Hexagon TESA RUGOSURF 10G Mode D'emploi

Value storage

17.4
Your RUGOSURF 10G allows you to store up to 999 measured values in the memory.
With full memory, the gauge unit displays an error message warning you that value storing is no longer
possible unless values are erased. To have the values of stored measurements be printed out, press
the appropriate printer key.
Note
The measured values can neither be selected nor recalled individually. They are printed out all together
as a listing. Rugosoft is the only software that permits full control in this respect.
Output can be repeated as long as all values are still in the memory. You may also check them one after
the other according to the procedure below.

Enabling/disabling stored values

17.4.1
To access this menu option, select
Press ENTER to enable or disable
The status bar shows the number of stored values, e.g.

Displaying all stored values

17.4.2
From menu Memo settings, press the cursor
through ENTER
Use the cursor , or the key
Press ENTER to return to sub-menu

Cancelling all stored values

17.4.3
From menu Memo settings, use the cursor
ENTER
The following warning message appears
Press ENTER to confirm or the left arrow key
6999.006.1503
Memo Settings, and then validate over ENTER
Disable
Memo function. Press
to select the menu option Show, and then validate
to select another page or next measured value.
Memo Settings, or the key
to select the menu option Reset, and then validate via
to cancel this operation.
Page 15/22
Enable
to return to Settings menu.
to go back to main menu.
A. Mathier / March 15