Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Energy Meter (Fig. 3, 6)
•
1. Registration & Setup
1) Select a electrical outlet for the energy meter socket that is within 100meter (330 feet) open area from the gateway.
Reduce distance if obstacles are between the remote socket and the gateway.
2) Plug the energy meter socket into the electrical outlet.
3) Enable the WiFi reception on your iOS / Android device and run the "BRESSER Connect" app.
4) Select "Energy Meter" and then tap the " i " on the upper right corner to enter the settings display
5) Tap "OK" in the menu [Install a new sensor now?] or tap "Sensor list" and tap "+" to add a new sensor
6) Tap "Connect" on the app to search for the energy meter socket
7) Hold the large "LEARN" button on the socket for 3 seconds to start connection
8) Once connection is established, "Sensor is connected" appears and you have successfully registered your energy
meter. You may proceed to change the name and photo. Tap the "Save" icon on the upper right corner anytime to save
and exit. Return to the "Energy Meter" main display and your energy meter socket will appear
9) If connection fails, find another electrical outlet that is closer to the gateway and repeat steps 6 to 8 until a connection
is established
10) Connect an electrical device to the your energy meter socket and it will provide power, energy & cost readings on
your app
Internet Remote Access
If you are not at home, you can still access to your sensors and sockets via the Internet
Activate the remote access function
•
Enter the home screen and tap the "i" icon on the top left
•
Tap "Remote Access Setting"
•
Tap "Activate Remote Access" and create a password to activate the remote access function
Note: You can have multiple smart phones or tablets to access your sensors remotely via the Internet. Follow above pro-
cedure to activate remote access function for each of your iOS / Android devices one by one.
IMPORTANT: You must always enter the same password that was created by the first device!
Remote access
Once the remote access function has been activated on your iOS / Android device, you can access your sensors and socket
via the Internet, using your mobile data (cellular data) network or remote WiFi network.
•
Make sure your iOS / Android device has access to the Internet
•
Run the BRESSER Connect app
•
Enter the password as requested
Password
To change your password
•
Connect your iOS / Android device to the gateway via your home's WiFi Gateway
•
Enter the home screen and tap the "i" icon on the top left
•
Tap "Remote Access Setting"
•
Tap "Change Remote Access Password" and recreate new password
Note: You cannot change your remote access settings in remote access mode.
IMPORTANT: If you forget your password, the only way is to follow above procedure to recreate a new password.
Other Settings:
Weather Forecast's location
1) In "Weather" main display, tap the " i " on the upper right corner to enter the setting display.
2) Tap "Location Setting".
3) Tap "+" on the upper right to add a new city.
4) Follow the steps and select the city name.
Note: You need to have Internet access enabled on the WiFi router in order to access the weather forecast information.
General Setting
"General setting" is available in the "Weather", "Garden" and "Energy meter" menue.
Weather: Temperature, rainfall and wind speed unit setting
Garden: Temperature unit setting
Energy Meter: Setting for tariff rates, currency and date
DE
GB
FR
NL
IT
ES
21
Publicité
Table des Matières
