Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BRESSER Connect
Home Automation with Remote Access for iOS & Android Devices
Thank you for purchasing the new BRESSER Connect system. This instrument will allows you to use your iOS / Android
devices to monitor and control your home sensors and power devices wirelessly via your home network or Internet. Read
this manual carefully to fully explore the features and functions of the new product
Scope of deliveries (Fig. 1)
Before installing please check the completeness of the scope of deliveries:
A)
Wind meter
with mount brackets and screws
B) Rain gauge
with cement dowel and fixing screws
C) Thermo-hygromneter
D) Soil moisture sensor
E) Energy meter socket
F)
Gateway
G) Mains adapter
User manual
Instruction Manual
To operate the devices contained in the set, the following batteries are required (not included):
4 x AA, 2 x AAA, 1 x CR2450, 3 x LR44
Parts Scheme (Fig. 2 and 3)
Basic functions:
1.
Gateway: Communicates between the remote devices (sensors & sockets) and the WiFi router
2. Wind meter: Provides wind speed/ direction, temperature & humidity measurements
3. Rain gauge: Provides rainfall measurements
4. Thermo-hygrometer: Provides temperature & humidity measurements
5. Soil moisture sensor: Provides soil moisture, soil temperature & air temperature measurements
6. Energy meter socket: Provides energy, electricity power & cost measurements
Additional tools needed for installation
•
Small Phillips screwdriver
•
Hexagonal Key
•
Electric drill
•
Pencil
•
Level
•
Mast, 1 – 1.25 inch (2.54 – 3.18 cm) in diameter (to mount the wind meter)
App download (BRESSER Connect)
Please download and install the app from Apple Store (iOS device) or Google Play (Android device).
Name of the app: BRESSER Connect
Note: Please setup the WiFi gateway before the other sensors, then setup the sensor one by one. (Do not set up multiple
sensors at the same time!)
Setting up the gateway (Fig. 2, 1)
1)
Connects LAN cable of the gateway to one of the available port on the back of your WiFi router
2)
Connects the 4.5V adapter to the gateway and the green LED will flash quickly for initial startup. Wait until the LED
stops the continuous flashing and the startup is completed
(Make sure the WiFi router is turned on before switching on the gateway)
16
Publicité
Table des Matières
