AL-KO SOLO R7-62.5 Traduction De La Notice D'origine page 16

GB
WARNING!
Danger if the starter battery is not
handled correctly!
The following points must be complied
with to avoid the dangers arising from in-
correct handling of the battery!
■
Do not store the starter battery in the immedi-
ate vicinity of naked flames, do not burn it or
place it on heaters. Risk of explosion.
■
Store the starter battery in a cool, dry room
(10 - 15 °C) over the winter. Avoid storing at
temperatures below the freezing point.
■
Do not leave the starter battery without
charge for a long period. If the starter battery
is not used for a long period, it should be
charged using a suitable charger.
■
Do not smash the starter battery. The electro-
lyte (sulphuric acid) causes chemical burns to
the skin and clothing – immediately rinse
away with plenty of water.
■
Keep the starter battery clean. Only wipe
clean with a dry cloth. Do not use water, pet-
rol, thinners or similar for this purpose.
■
Keep the connection terminals clean and
grease them with terminal grease.
■
Do not short-circuit the connection terminals.
CAUTION!
Danger of a short circuit!
To avoid a short circuit, always discon-
nect the negative cable (-) of the battery
first, and reconnect it last!
Always remove the ignition key before
starting work on the battery!
1. Unscrew screw (24/1) of the bonnet.
2. Move control lever (24/2) of the mower deck
into the upper position.
3. Swing bonnet (24/3) to the side to access the
battery holder.
4. Install the battery (25/2) in the holder provid-
ed. Secure the battery with the rubber strap
(25/3) provided.
5. Connect the battery cables to the terminals of
the battery; connect plus terminal (25/1) first,
then minus terminal (25/4).
6. Close the bonnet, insert and tighten screws
(24/1) again and move control lever (24/2) of
the mower deck back into the lower position.
16
All manuals and user guides at all-guides.com
NOTE
Check the polarity:
■
Red terminal = positive terminal (+)
■
Black terminal = negative terminal
(-)
6 START-UP
See also the ride-on mower operating instructions.
WARNING!
Danger if assembly is not carried out
completely!
Do not operate the ride-on mower before
it has been fully assembled!
Carry out all the work described in the
assembly instructions. If you are uncer-
tain about anything, ask a specialist to
confirm that the assembly has been car-
ried out correctly before the machine is
started up!
Check whether all safety and protective
devices are in place and functioning cor-
rectly!
6.1 Check tyre pressure (26)
The correct tyre pressure is an important prereq-
uisite for a correctly levelled mower deck, and
hence for a uniformly mown lawn. Check the tyre
pressure at regular intervals.
1. Park the ride-on mower on firm and level
ground and remove the ignition key.
2. Wait for approx. 1 hour after operation to al-
low the tyre to cool down. The tyre pressure
can only be measured correctly when the tyre
is cool.
3. Unscrew the valve cap and press a tyre pres-
sure meter onto the open valve.
4. Read off the tyre pressure and compare it
with the values given on the tyre: 1.0 –
1.4 bar.
5. If the tyre pressure is too low: Pump up the
tyre using a commercially available foot
pump.
NOTE
1 PSI = 0.07 bar.
R7-62.5 | R7-63.8 A | R7-65.8 HD
Start-up