Publicité
Les langues disponibles
Les langues disponibles
ALL-SEASON ATV TRACK KIT
KIT PN 2876664
6.4. Track Adjuster Replacement
The following steps refer to one track adjuster. However,
all four track adjusters follow the same procedure for
installation and removal.
1. Raise the ATV off the ground.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Remove the track following the procedure described
in section 6.1. - Track replacement.
3. Remove the wheels of the track adjuster following
the procedure described in section 6.3.2. - Large
wheel replacement.
Figure 33 - Removal of the large wheels
4. Unscrew and remove the 3/8" nc bolt and the
3/8" nc thin nut retaining the track adjuster to the
structure. Save the flat washer.
Figure 34 - Removal of the track adjuster
2510266
A-2510266 Rév. A
5. Remove the track adjuster.
Figure 35 - Track adjuster removed
6. Unscrew the 1/2" nc X 4" bolt from the track
adjuster and remove it.
7. To reassemble the kit, reverse the steps and apply
the torque listed in Table 1 - Specifications of the
tightening torque.
- 24 -
Publicité
