Polaris PROSPECTOR II Manuel D'installation page 50

ALL-SEASON ATV TRACK KIT
KIT PN 2876664
6.3. Wheel Replacement
The following steps refer to one wheel. However, all the
wheels follow the same procedure for installation and
removal.
6.3.1. Small Wheel Replacement
1. Raise the ATV off the ground.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Remove the tension in the track as described in
section 6.1. - Track replacement.
3. Unscrew the 3/8" nc X 1" bolt retaining the wheel
to the structure. Make sure to save the flat washer
and the lock washer.
4. Press downwards on the track to loosen the track
and to replace wheels.
Figure 31 - Removal of the wheels
5. To reassemble the kit, reverse the steps and apply
the torque listed in Table 1 - Specifications of the
tightening torque.
WARNING
If a lock washer is permanentaly deformed and does
not offer adequate resistance, it should be
immediately replaced.
2510266
A-2510266 Rév. A
6.3.2. Large Wheel Replacement
1. Raise the ATV off the ground.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Remove the tension in the track as described in
section 6.1. - Track replacement.
3. Unscrew the 3/8" nc X 1" bolt retaining the wheel
to the structure. Make sure to save the flat washer
and the lock washer.
4. Replace the wheel as follows :
4.1. Gather all the slack of the track towards the
area of the track adjuster.
4.2. Pull on the flange of the wheel towards outside
of the Track Kit and take it off.
Figure 32 - Removal of the large wheels
5. To reassemble the kit, inverse the steps and apply
the torque listed in Table 1 - Specifications of the
tightening torque.
WARNING
If a lock washer is permanentaly deformed and does
not offer adequate resistance, it should be
immediately replaced.
- 23 -