Publicité
Les langues disponibles
Les langues disponibles
ALL-SEASON ATV TRACK KIT
KIT PN 2876664
SECTION 3 : ADJUSTMENTS
WARNING
Adjustments should be made by a dealer or a
competent mechanic.
WARNING
These adjustments should be made on a hard, flat,
and level surface.
3.1. Front Track Kit Adjustments
1. Park the vehicle on a flat levelled surface.
2. The anti-rotation adjustments will be done by
measuring the distance between a carpenter square
edge to the center line of the wheel (see Figure 12).
3. Align the carpenter square to the center line of the
hubcap.
4. Loosen jam nut on the anti-rotation ball joint.
5. Turn the guiding axle using the notches and an
adjustable wrench to screw the ball joint in or out in
Guiding Axle
1"
Adjustable
Wrench
Figure 12 - Front Track Kit adjustments
2510266
A-2510266 Rév. A
Thin Jam Nut
a way to adjust the anti-rotation lenght. Screwing the
ball joint in will reduce the distance between the edge
and the wheel center line. Screwing the ball joint out
will increase the distance between the edge and the
wheel center line. Use 5 in. (127mm) as initial set up.
6. Tighten the anti-rotation jam nut on the ball joint.
Adjustment verification :
After initial adjustment of the front and rear tracks,
ride the vehicle carefully a few minutes to have a
feeling of its behaviour.
The front tracks can be readjusted if required for your
personal type of ride.
Increasing the distance will have the effect of making
steering harder and very stable ride.
Reducing the distance will decrease steering effort
and can make machine feel "darty" or "twitchy" at
speed.
WARNING
Make sure that the handlebars are not turning by
themselves during braking or steering attempts. If it
is the case, the handlebars could suddenly move
when you do not expect and you can get ejected
from the vehicle. Serious injury or death may result.
Repeat steps if required.
- 15 -
Front right track shown
Front of the ATV
Publicité
