Publicité
Les langues disponibles
Les langues disponibles
ALL-SEASON ATV TRACK KIT
KIT PN 2876664
SECTION 6 : PARTS REPLACEMENT
WARNING
Always clean the Track Kit after use to prevent
debris accumulation inside the frame. Failure to do
so will result in premature wear of components.
WARNING
Never use solvants to clean rubber tracks as these
substances may cause rapid degradation of the
rubber. Use only water with mild detergent.
6.1. Track Replacement
The following steps refer to one track. However, all four
tracks follow the same procedure for installation and
removal.
1. Raise the ATV off the ground.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Unscrew the 3/8" nc thin nut retaining the track
adjuster to the structure.
Figure 22 - Thin nut of the track adjuster
2510266
A-2510266 Rév. A
3. Loosen the 1/2" jam nut (A) of the adjustment bolt
on the track adjuster using the track tension
adjustment tool (B).
Figure 23 - Track tension adjustment tool
4. Unscrew the adjustment bolt completely.
Figure 24 - Removal of the adjustment bolt
5. Remove the two large wheels placed opposite the
track adjuster following the procedure in section
6.3.2. - Large wheel replacement.
Figure 25 - Removal of the large wheels
- 20 -
Publicité
