Publicité
Les langues disponibles
Les langues disponibles
ALL-SEASON ATV TRACK KIT
KIT PN 2876664
6. Remove the track.
WARNING
When you install the track, pay particular attention
to its direction. An arrow on the track points towards
the front of the vehicle when looking from the top.
Figure 26 - Direction of rotation of the track
7. Reverse procedure to install track.
8. Adjustment are performed as follows : Refer to
section 3.3 for track tension adjustment.
2510266
A-2510266 Rév. A
6.2. Sprocket and Main Axle Replacement
The following steps refer to one sprocket and main axle.
However, all four sprockets and main axles follow the
same procedure for installation and removal.
1. Raise the ATV off the ground.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2. Remove the track following the procedure in
section 6.1. - Track replacement.
3. Unscrew the bolt and nut connecting the structure
and the anti-rotation assembly.
Figure 27 - Removal of the front and rear anti-rotation
- 21 -
Publicité
