Publicité
Les langues disponibles
Les langues disponibles
ALL-SEASON ATV TRACK KIT
KIT PN 2876664
Figure 8 - Front anti-rotation assembly onto the Track Kit
4. Repeat steps 1 to 3 for the other side and refer to the
section 3 for various adjustments.
WARNING
Prior to installation of the Track Kit, turn off the
engine, put in two-wheel driving mode, and block
the rear wheels.
WARNING
When the ATV is raised, make sure that it is properly
secured/supported to prevent it from accidentally
falling during the installation of the tracks. If not
properly secured/supported, serious physical injury
could occur.
2.2. Rear Tracks Installation
1. Install front subtable per the instructions included
with the mounting kit.
WARNING
Do not inverse the right and left side.
Do not inverse the front and rear kits.
2510266
A-2510266 Rév. A
Front left shown
Bowed shape on
the ground
Figure 9 - Front and rear left pre-assembled Track Kit
2. Install the rear pre-assembled Track Kit on the
ATV hub, in the same place where the wheel had
been installed. Use the
with the mount kit. Apply a tightening torque of 35
ft-lbs.
NOTE : Retorque after one hour of use.
3. Assemble the rear anti-rotation on the Track Kit
following these steps (see Figure 10) :
3.1. Install the anti-rotation (A) onto the pre-
assembled Track Kit using the bolt (B), the
3/8" dia flat washer (C), the tightening spacer
(D), and the nylock nut (E) supplierd with the
mount kit. Torque to 25 ft-lbs.
WARNING
The washer and the spacer are very important; they
prevent the nut from coming loose.
- 13 -
Rear left shown
Flat shape on
the ground
flange nuts supplied
3/8" nf
Publicité
