Renfert Twister Traduction Du Mode D'emploi D'origine page 30

6.5 Changing inlet filter
Twister venturi only
en
In the Twister venturi units there are two different types of inlet filters:
► Current version:
Inlet filter internally, behind the compressed air connection
(Fig. 15-a).
⇒ Disconnect the appliance from the compressed air supply�
⇒ Press the compressed air connection ring (11) upwards and remove the
compressed air tube (17)�
⇒ Loosen the compressed air connection screw fitting (11) and remove the
filter (12).
⇒ Screw the new filter into the compressed air connection, replace the
screw fitting and hand-tighten.
⇒ Plug the compressed air tube (17) into the tube attachment on the com-
pressed air connection (11) as far as it will go, passing the point of slight
resistance�
⇒ Reconnect the appliance to the compressed air supply�
► Previous version:
Inlet filter hidden, behind the compressed air connection (Fig. 15-b).
⇒ Disconnect the appliance from the compressed air supply�
⇒ Press the ring on the inlet filter (12) up and pull the compressed air
hose (17) off�
⇒ Press the ring on the compressed air coupling (11) up and pull the inlet
filter(12) off.
⇒ Insert a new inlet filterto the compressed air coupling, passing the point
of slight resistance�
⇒ Insert the compressed air hose to the new intake filter, passing the point
of slight resistance�
⇒ Reconnect the appliance to the compressed air supply�
Frequent inlet filterblockage is an indication of contaminated com-
pressed air. In such cases we recommend the upstream installation
of a filter pressure regulator (see section „3.3 Accessories").
6.6 Changing the silencer
Twister venturi only
⇒ Unscrew and remove silencer (10)�
⇒ Fit and screw in new silencer�
6.7 Spare Parts
You can find components subject to wear and the spare parts on the spare part list in the
internet at www.renfert.com/p918�
Enter the following item number: 18260000 or 18270000�
The components excluded from the warranty (such as consumables or parts subject to
wear and tear) are marked on the spare part list�
Serial number and date of manufacturing are shown on the type plate of the unit�
- 12 -
12
11
17
Fig. 15-a
11
12
17
Fig. 15-b
10
Fig. 16