Renfert Twister Traduction Du Mode D'emploi D'origine page 28

5.5.1 Abort mixing process
⇒ Stop the mixing process: Press the control knob once�
en
♦ The appliance will beep�
♦ Mixing process being aborted
⇒ Hold the bowl!
⇒ Aerate bowl: Press the control knob�
♦ The bowl will be released in a few seconds�
⇒ Remove the mixing bowl�
5.5.2 Power cut
Twister only
If a power cut should occur or the appliance is switched off during a mixing operation, the vacuum will be
maintained and the bowl will stay on the device�
When the power returns or the device is switched back on again, the bowl will become ventilated
and then fall off.
Twister venturi only
In case of a power failure or if the appliance is switched off, the bowl will be vented and be uncou-
pled.
5.6 Adjustment During the Mixing Process
All the mixing parameters can be displayed in large-scale characters during the mixing process if you
press the relevant parameter key�
The parameters can also be changed during the mixing process by pressing the relevant parame-
ter key and turning the control knob.
Changes made to the mixing parameter settings during the mixing process will be applied to that
mixing process only and will not be saved.
6 Cleaning and Maintenance
Switch off and unplug the appliance before cleaning or servicing.
6.1 Housing
Do not steam clean the appliance.
Do not use solvent-based, aggressive or scouring cleaners.
⇒ Switch the appliance off�
⇒ Disconnect from mains�
⇒ Wipe housing with a damp cloth�
6.2 Seal Surfaces
The following seal surfaces must always be kept clean in order to ensure
correct vacuum built up and the secure retention of the mixing bowl during
the mixing process:
• Seal between the paddle and the bowl (25)�
• Seal between the appliance and the paddle (26)�
Tip
You should regularly coat the rubber seals with Vaseline.
This will significantly increase their service life and optimize to appli-
ance's function
- 10 -
26
25
Fig. 10