Publicité
Safety Notes
• This locomotive is only to be used with the operating
system it is designed for.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the satety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
14972 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The wire used for feeder connections to the track may be
a maximum of 2 meters / 39 inches long.
• WARNING! Sharp edges and points required for operation.
General Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
8
All manuals and user guides at all-guides.com
Functions
• Built-in electronic circuit for operation with a conventio-
• Automatic system recognition between digital and analog
• No automatic system recognition between Selectrix (SX)
• Built-in headlights that change over with the direction of
Notes on digital operation
• The first time the locomotive is used in a digital system
• The setting done at the factory does not permit operation
• In digital mode, the light in the carriage is permanently on
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
nal DC power pack (max. ±12 volts), Trix Systems,
Trix Selectrix or NMRA DCC digital systems.
operation.
and DCC.
travel. They can be turned on and off in digital operation.
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed
once in this digital system
(Example: changing an address).
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29 / Bit 2 = 0).
and is not switchable.
Publicité
